Water heater leaking or sparking: act first
A heater that leaks at the tank body is rarely repairable, and the water can reach drywall or flooring within minutes. Leaks at a fitting, a drain valve or the relief valve are often fixable.
If you smell gas, do not touch switches. Leave the house, then call the gas utility or 911 from outside.
- Turn the cold water supply valve above the heater clockwise to stop the refill.
- Switch off the breaker for an electric unit, or set a gas unit to pilot or off.
- If you smell gas, leave and call the gas utility or 911 first. Florida Public Utilities lists 561-832-0872 and TECO Peoples Gas lists 877-832-6747 on the city emergency contacts page.
- Call the 24/7 line and tell us whether the water is from the tank, a pipe or the relief valve.
Take a photo of the data plate on the tank. The model and serial numbers let us arrive with the right parts.
What the symptom usually points to
Most no-hot-water calls come down to a short list of causes.
- No hot water on an electric tankA tripped breaker, a failed upper or lower heating element or a bad thermostat is the usual cause.
- No hot water on a gas tankThe pilot may be out, the thermocouple may have failed or the gas control valve may be faulty.
- Water too hot or not hot enoughA thermostat setting, a failed thermostat or a sediment layer on the bottom of the tank.
- Rumbling or poppingSediment sits on the bottom and boils under the burner or element.
- Rusty hot water onlyThe tank interior or the anode rod is breaking down, which often means replacement is near.
Repair or replace: how we decide
A tank that is under ten years old and leaks at a fitting is worth fixing. A tank that has rusted through, or that needs several parts at once, is usually not. We tell you which category yours is in before any work begins.
Age is only part of it. A water heater in a garage with good ventilation can outlast one in a closet that floods once. We look at the tank, the venting, the temperature and pressure relief valve and the drain pan before giving a recommendation.
If replacement makes sense, our page on water heater replacement explains how that visit works and how same-day scheduling is handled. Manufacturer guidelines call for testing the temperature and pressure relief valve at least once a year, and we check it on every repair visit.
Common repairs and what they involve
The parts that fail most often are inexpensive. Labor and access are the larger share of the visit.
| Fault | Likely part | Result of repair. |
|---|---|---|
| Cold water at every tap | Element, thermostat or gas control | Hot water returns after the new part heats. |
| Water around the base | Drain valve, fitting or tank | Fittings are repairable, tanks are not. |
| Relief valve dripping | Valve or pressure problem | Valve replaced, pressure tested. |
| Pilot keeps going out | Thermocouple or draft | Pilot stays lit, venting checked. |
| Breaker keeps tripping | Shorted element | Element replaced, wiring checked. |
Hybrid and heat pump water heaters
Some newer homes use hybrid heat pump water heaters, which pull heat from the surrounding air. They have a compressor, a fan and a condensate line in addition to the usual tank parts. A clogged condensate drain or a dirty air filter can shut one down.
We service these units but they need parts from the manufacturer, so a model number is essential when you call. If the heater is in a garage, the air around it matters, so we check clearances too.
Cold shower and a wet floor?
Call the 24/7 line. We will tell you what to shut off while a plumber is on the way.
Water heaters in Palm Beach Gardens homes
South Florida homes keep their water heaters in garages, closets and utility rooms, and a leak in an interior closet can reach carpet fast. In slab homes, drain pans and a pan drain line carry small leaks out of the house. We check that line on every visit because a blocked pan line turns a drip into damage.
The Seacoast Utility Authority reports that its drinking water uses chloramine, with 2025 samples averaging 3.7 ppm. Chloramine is a normal disinfectant, but it can wear rubber parts such as seals and flappers faster than plain chlorine does, so we look at rubber fittings during service.
What affects water heater repair cost
The final number depends on the part and the access.
How a repair visit runs
Make safe
We shut off water, power and gas as needed.
Test
We check the thermostat, element, burner and venting.
Repair
We replace the failed part and flush sediment when it helps.
Verify
We confirm temperature, check the relief valve and clear the drain pan line.
Questions we hear most
Yes. The 24/7 line at (561) 448-8545 is answered nights, weekends and holidays. A plumber can be dispatched the same day when a slot is open.
On an electric unit the breaker, element or thermostat is the usual cause. On a gas unit the pilot or thermocouple is the first place to look.
A leak from the tank body means replacement. A leak at a fitting, valve or the relief line can often be repaired.
Close the cold supply valve above the heater, shut off power or gas and mop up standing water. If you smell gas, leave and call from outside.
Yes, though tankless units often need a descale or an error code check. See tankless water heater service.
If the tank body is leaking, is rusting or is more than ten years old and needs a major part, replacement is usually better. We explain the numbers on site.
